| It is necessary to check the accuracy of the machine before- | | CounterPlate is made. |
|
（Accuracy doesn't go out of CounterPlate and MENPITA if accuracy has not gone out to the machine. ） It improves it by the numerical correction if it says to machinery manufacturer. |
| ① |
 | Following CounterPlate is made with the machine. The hole of 22mm pies per four corner of 300mm corner is cleared in 30mm. Attention...Please make the hole of 22mm pies tight a little so that there is no space in the Guide. |
| ② |
 | The seal is removed in horizontal respect such as 1 and desks and Patch is bonded. |
| ③ |
 | It covers Patch with Guide. |
| ④ |
 | It puts a Patch in "Another Guide", and the seal is removed. Attention...Please put the hardboard of the collection in the Guide when the height of the Patch is low. The Guide shifts when bonding is weak. |
| ⑤ |
 | It transcribes in the hole of COUNTER-PLATE and after MENPITA-GUIDE of "4" is put, the mark is transcribed in MENPITA-GUIDE of "2" ..including the difference it as for the hole of COUNTER-PLATE... |
| ⑥ |
 | The MENPITA-MARK and the MENPITA-GUIDE of two holes of the remainder are similarly transcribed. |
| ⑦ |
 | COUNTERPLATE is the horizontal compared with the stand and it is confirmed to record without difficulty. |
| ⑧ |
 | Please confirm the thing not distorted. |
| ⑨ |
 | Next, COUNTERPLATE is rotated in "90°", and it puts it on the MENPITA-GUIDE. Moreover, please return and confirm the back while turning. |
| ⑩ |
 | The accuracy of "Length" and "Side" of MILLING-MACHIN will not have gone out when COUNTER-PLATE is abnormally distorted at this time or resistance is large. |
| ⑪ |
 | Please inquire of the MILLINGMACHIN manufacturer if abnormality that COUNTERPLATE is distorted and enters is found in the MENPITA-GUIDE. |
|
