The arrangement method of DIE-RING:CADMEN world

CADMEN

world

Method of arranging DIERING

The hole arrangement of the hole of Die-ring is different in RIPITA and usual Counter-plate.

Hanging down occurs in Counter-plate of the double-faced tape and it doesn't become Cutting-plate from externals to touch and to put it on if it doesn't suppress it to 250mm or less between Die-ring holes within 125mm usually. (Though it is somewhat good. )

When the hole of 250mm in the diameter is drawn from Diering, it is comprehensible.

Basic chart

Explanation) The basis is assumed to be 2 piece transcript. If yen of 250mm can be covered, it usually takes account very much though it is OK, the hole position of Diering is centered to the last, and Counter-plate of the double-faced tape is pushed in. It pushes it in without thinking about anything for Ripita.

Dividing is easy shape to set.

The explanation) It is produced to divide into two by the front page in a big thing of AMERIKANROCK and BOTTUMROCK, and there is no uselessness and COUNTERPLATE can be produced.

It is necessary to clear the hole another one three so that there is a center part when it is usual two sided tape addition COUNTERPLATE ..hanging down turning over [duki].. though two four of the 2nd and 3 in RIPITA can be arranged.

Arrangement method in front page

Explanation) It bonds when it is usual two sided tape addition COUNTERPLATE and it distorts though it is arranged accurately after pushing at the position of MENPITA even if upper right and the part under the left touch in RIPITA. It wishes without fail by arranging 4 pieces.