The accuracy problem of a DieCutting machine:CADMEN world

CADMEN

world

If the clearance of Chace and DirCutting machine is large,-

it will rotate, or there is gap to depth.

Since the matrix TAPE itself shifts well and it comes to a center so that it may go into a center, the DieCutting spot which does not recognize DieCutting machine accuracy has very many matrices tape.
Please check by the following method.

When inaccurate, adjustment is required of the DIECUTTINGMACHINE maker

①

DIE is attached in CHACE and it puts into the inside of a plane.

②

CUTTINGPLATE is pulled out, and a broad tape is stuck on "the part where knife hits" so that "the direction of length" and a "transverse direction" of STEELRULE may be covered.

③

CUTTINGPLATE is put in and it is a line chair about 1 time and a press.

④

CHACE is pulled out and CHACE is put in again.
　(It is better for pulling out to pull out the whole CHACE.) It may be hard to come out of an error if it is a short drawer distance.

⑤

Again, it presses.

⑥

4-5 are repeated about 3 times.

⑦

CUTTINGPLATE is pulled out and "the marks of knife" attached to the tape is checked.

⑧

If all "marks of a knife" is located in the same position, a problem is not in accuracy.

The accuracy of DIECUTTINGMACHINE is poor if the position of a knife has shifted. Please carry out an adjustment request at the DIECUTTINGMACHINE maker.